磷叶石(磷页石)是一种什么样的矿物,价格如何?
的有关信息介绍如下:
刚刚帮人从玻利维亚买了块…品相不是很好,170美元含运费
ebay是个好东西…
作为前化学吧水b…自然是考虑了一下怎么做的问题…于是找到了这篇文献…
然后晶化吧翻了翻水热法做出来的晶体也就一毫米那么大…
Phosphophyllite was synthesized by adding a solution of diammonium hydrogen phosphate, (NH4)_2HPO _4 (0.5 mol dm^-3, 30 cm^3) to a solution of zinc sulfate and iron(II) sulfate (total [M^2+]= 0.5 mol dm^- 3, 70 cm^3) with stirring. The result- ant precipitate was left stirring for 4 h and then filtered using a grade 3 sintered glass crucible, washed with 1 dm3 distilled water to remove excess sulfate, and then air-dried at 60°C. The total concentration of metal ions in the reaction was kept constant but their molar ratio was varied. With less than 40% iron in the reaction mixture hopeite was formed as well as phosphophyllite, but with 40% Fe2+ and above the mixed zinc/iron phosphate was the only product formed. Powder X-ray diffraction was used to identify the solids formed. The first reflection in the powder pattern for both hopeite and phosphophyllite occurs near 28 = 10" for Cu-Ka, radiation; these peaks occur with approximately equal intensities but with a separation of 0.3". It is thus possible to determine the relative quantities of each phosphate in a mixture from the ratio of these peak intensities.
期待中科院上海硅酸盐研究所有兴趣的教授能把这个项目交给某个博士生,否则…我们就要自己动手了!水温不均匀是个很大的问题…
附翻译的大意:30mL的0.5mol/L磷酸氢二铵溶液,加上70mL的硫酸锌与硫酸亚铁的混合溶液(总二价金属盐含量为0.5mol/L),搅4个小时,(然后用烧结玻璃??)3级砂芯漏斗?和一升蒸馏水洗掉残硫酸,60度下空气干燥,后面就是分析了交给诸位博士生(
看起来不太难的样子,不过估计是流体力学限制与温度问题导致了总反应液体积只有0.1L,反正原料好搞,有时间的就…将就做一下?
想要文献的…算了我还是想办法找个published的页面好了…
Synthesis, Structure and Thermal Properties of Phosphophyllite
Ian M. Thomas and Mark T. Weller*
Department of Chemistry, The University of Southampton, Highfield, Southampton SO9 5NH, UK
反正有SCI-hub,大家直接下载好了(
@博丽灵梦 问问化院里有没有愿意玩的在实验室搞一个?



